Page 545 - The Central Motor Vehicles Rules, 1989

FORM 22B THE CENTRAL MOTOR VEHICLES RULES, 1989 517

(iii) Arm rest width
(iv) Seat cushion depth

(v) Seat spacing
(vi) Seat base height
(vii) Torso angle
(viii) Seat base thickness
(ix) Seat back thickness
(x) Clearance leg space
(xi) Free height over seating position
(xii) Intrusion over seating position

Whether following are provided as stipulated in Bus Body Code AIS:52
Rev. I (amended time to time).
Important Note : In case if the compliance is reported as “No” then vehicle
shall not be registered.
6.17 Driver work area: (Yes/No)
Note : Driver door, climb facility, hand holds, work area dimensions,
position of steering wheel, placement of instrument panel, shroud for
wiring harness, position of controls, heating/cooling/ventilation for
the driver to be provided as specified in the bus body code.
6.18 Standee passenger area: (Yes/No)
Note: Standee passenger area to be determined and provided as
specified in the bus body code.
6.19 Designed seating and standee passenger capacity: (Yes/No)
Note : Enclose a sheet indicating calculations of the seating and
standing passenger capacity based on the procedure specified in the
bus body code along with layout of seats and standees area.
6.20 Public information system (audio/visual/audio visual): (Yes/No)
6.21 Materials used for body insulation (Yes/No)
6.22 Type approval of rear view mirrors (Yes/No)
6.23 Wind screen wiping system and driver field of vision: (Yes/No)
Type approval details of the wiping system components
Note:
1. Wind screen wiping system and driver field of vision to be
provided in accordance with requirements specified in the
bus body code.
2. Installation performance compliance to be submitted.