Page 672 - The Central Motor Vehicles Rules, 1989

644 THE CENTRAL MOTOR VEHICLE RULES, 1989 ANNEXURE XI

• Additional safety features such as 2 Nos. of dry powder type fire
extinguishers of 2 kg each shall be provided one in driver’s cabin and
another in passenger compartment. Gas leakage detector will further
enhance safety.
• For electrical installation, flameproof cables shall be used, especially
positive terminals shall be locked firmly with all cables and pipes with
proper looming to take care of vibrations; fire retardant material shall be
used for seat/upholstery/roof and side lining. Safety instructions about
alterness in case of gas leakage and fire hazard shall be displayed.
Note : The AIS standards referred to in this Annexure are available with the
Automotive Research Association of India (ARAI), P.B. No. 832, Pune 411004, India (Fax:
91-20-5434190, Website: http://www.araiindia.com). Copies of this document are also
available with the other testing agencies, as referred to in rule 126 of the Central Motor
Vehicles Rules, 1989.]

1
[ANNEXURE XI
[Refer clause(s) of rule 2, rule 16 and rule 48] ANNEXURE XI
I. Specifications of laminated card type without chip or Smart Card type Driving
Licence and Registration Certificate
(a) Integrated Circuit Card (ICC, commonly known as contact smart card) or
Proximity Integrated Circuit Card (PICC, commonly known as contactless
smart card).
(b) ICC shall be compliant to ISO/IEC 7816-1, 2 and 3 while PICC shall be
compliant to ISO/IEC 14443-1, 2, 3 and 4.
(c) Both ICC and PICC shall also be compliant to ISO/IEC 7816-4, 8 and 9,
IS-16695 Part I, 2018 (commonly known as SCOSTA).
(d) Minimum 10 years data retention for the non-volatile memory in the form
of EEPROM or FLASH.
(e) Minimum 300,000 write cycles endurance for the non-volatile memory.
(f) The hardware (controller) shall be in compliance and certified to be EAL4+
(or higher) common criteria certificate along with security target of
evaluation of microcontroller (in case of ROM based OS implementation)
or of the microcontroller along with Boot loader/Flash loader/Smart
Program/Boot Program (in case of Flash based OS implementation) under
the Common Criteria Certificate. The common Criteria Certificate refers to
BSI-CC-PP-0035-2007/BSI-CC-PP-0084-2014 (or newer) Protection profile.
(g) The operating system shall be loaded in the Flash Memory or in the ROM
with the chip at wafer level in the facility fully owned by the chip
manufacturer and shall be locked at that facility in a way that it cannot be
altered, modified, erased or deleted either selectively or wholly.

1 Substituted vide GSR 174(E), dt. 1-3-2019, w.e.f. 1-10-2019